1. Fix the machine horizontally on the flat cement floor, check whether all parts of the machine are intact and firm, and whether the cutting machine line is smooth.

2. Erase the stains and debris on the upper pressure plate and workbench surface.

3. Inject 68 # or 46 # anti-wear hydraulic oil into the tank, and the oil level shall not be less than the oil filter net

4. Connect 380V three-phase power supply, press the starting button of the oil pump, adjust and keep the motor steering consistent with the direction of the arrow.

2. aramid fabric operation instructions

1. First turn the cutting controller (trimmer knob) left to zero.

2. Turn on the power switch, press the starting button of the oil pump, run for two minutes without load, and observe whether the system is normal.

3. Place the push-pull plate, rubber plate, workpiece, and tool die in the middle of the workbench in sequence.

4. Set the die (die setting).

1. loosen the handle of the knife, naturally fall and lock.

②. Switch right turn, ready for trial.

③. Double click the green button for trial cutting, and the blanking depth is controlled by fine tuning.

4. Fine tuning: Turn the fine tuning button, left to reduce shallow, right to deepen.

⑤. Stroke adjustment: Rotate the rise height controller, right-handed stroke increases, left-handed stroke decreases, stroke can be freely adjusted in the range of 50-200mm(or 50-250mm), normal production of the above pressure distance from the top of the die about 50mm stroke is appropriate.

Special attention: Each time to replace the tool die, workpiece or plate, must re-set the stroke of the tool, otherwise, it will damage the tool die and plate.

aramid fabric Security matters:

①, in order to ensure safety, it is strictly prohibited to put hands and other parts of the body into the blanking area during operation. Before maintenance, it is necessary to turn off the power, and put wood blocks or other hard objects in the blanking area to prevent the upper pressure plate from getting out of control after pressure relief, resulting in accidental personal injury.

(2) Under special circumstances, when the upper pressure plate needs to rise immediately, you can press the reset button. When it stops, press the power brake button (red button), and the whole system will stop operation immediately.

③, the operation needs to hit the two buttons on the press plate with both hands, not at will to change a single hand, or foot operation.

aramid fabric https://www.hzcomposite.com/Aramid-Fiber-Fabric